User manual

8. DMX Connection

Use of XLR microphone cables may cause interferences in the DMX signal transmission. In this

case, please use special DMX high-frequency cables.

a) Connection of a DMX Controller

Only connect the device to a DMX controller with a DMX-512 protocol.

• Connect the DMX IN input to the DMX controller output.

• Use a screened XLR cable for this. The controller must have 2 free control channels.

• Connect the DMX OUT output to the DMX input of the next device in sequence. If the effect light is the last or only

device in the DMX chain, insert a plug with a 120 Ohm/0.25 W terminator here (between Pin2 and Pin3).

Pin assignment of the DMX connection: Pin1 = earth / Pin2 = (-) / Pin3 = (+).

Never connect the earth pin GND to the casing earth of the effect light; this may result in interference in signal

transmission caused by ground loops.