User manual

29
For a more detailed explanation of the individual menu items from the table, see the following items of these
instructions.
b) Use with an External DMX Controller
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identied by the control-
ler. This DMX starting address species the rst DMX channel to which the effect light responds. The remaining
control channels come after this rst DMX channel (DMX starting address).
The effect light requires 9 or 15 free DMX channels depending on the operating mode.
Setting the DMX starting address
• In the menu, select DMX Addr and push the ENTER button.
• Select the desired starting address 001-512 with the arrows.
• Press the ENTER button to conrm your selection.
Setting the DMX channel number
• In the menu, select CH Mode and push the ENTER button.
• Select the desired number of DMX channels (9 or 15) with the arrows.
• Press the ENTER button to conrm your selection.
Setting the operating mode DMX
• In the menu, select Work Mod and push the ENTER button.
• Select the option DMX with the arrows.
• Press the ENTER button to conrm your selection.
In DMX mode, the LED DMX next to the display will ash.
Setting master-slave mode
• In the menu, select Master and push the ENTER button.
• Select the option No = Slave mode or Yes = Master mode with the arrows.
• Press the ENTER button to conrm your selection.
If the device is to be operated as a single device (standalone), it must be dened as a master device.
Only one device in a master-slave-chain must be dened as master device. All other devices must be
dened as slave devices.
Depending on whether the device is dened as master or slave, the corresponding LED next to the display
will ash.