User manual

33
d) Sound-to-Light Mode
• PushthebuttonFUNC(5)until"SoUn"isdisplayedandpushthebuttonENTER(8).
• SelectthedesiredoperatingmodewiththeUP(7)andDOWN(6)buttons:
on Sound-to-light mode activated
oFF Sound-to-light mode deactivated
• PushtheENTERbutton(8)toconrmyourselection.
• Theeectlightiscontrolledviatheinstalledmicrophone(9)intimewiththemusicinthismode.
• Setthesound-to-lightcontrolsensitivitywiththeSOUNDSENSITIVITY(4)controller.Setthiscontroller
sothatthelighteectchangesintimewiththemusic.
 Sound-to-lightoperationtakesprecedenceoverautomaticmode.Alwaysswitchosound-to-
light control before choosing any other operating mode.
e) Display Settings
• PushthebuttonFUNC(5)until"Led"isdisplayedandpushthebuttonENTER(8).
• UsethebuttonsUP(7)orDOWN(6)toselectthedesiredoperatingmode:
on: Display permanently on
 oFF: Thedisplayswitchesoafterthelastbuttonispushed
• PushtheENTERbutton(8)toconrmthesettings.
Pushing the FUNC button (5) switches the display on again temporarily.
f) Master-Slave Mode
• PushthebuttonFUNC(5)until"SLNd"isdisplayedandpushthebuttonENTER(8).
• UsethebuttonsUP(7)orDOWN(6)toselectthedesiredoperatingmode:
NASt Master device
SL 1 Normal slave mode
SL 2 Inverted slave mode
• PushtheENTERbutton(8)toconrmyourselection.
If the device is to be operated as a single device (standalone), it must be defined as a master
device.
Only one device in a master-slave-chain must be defined as master device. All other devices
must be defined as slave devices.
In inverted slave mode, the device behaves opposite to the master device.
If the device has accidentally been defined as slave unit in stand-alone operation, the display (3)
shows"StbY"andtheeectlightiso.