User manual

27
• Attachtheeectspotlighttoasuitablemountingsurfaceoronasuitablecrossbeamwiththemounting
bracket. The assembly must never swing freely.
• Securethedevicewithassemblyequipmentthatiscompatiblewiththeattachmenttypeandsuitablefor
carryingtheweightoftheeectlight.
• Additionallysecuretheinstallationwithasuitablesafetyrestraintcableorasafetynet.Acorrespond-
ing ring is installed on the device for attachment of a safety catching rope. The safety retention rope or
thenetmustbedesignedtosupporttheeectlightintheeventoffailureofthemainsupportsystem
independently of the main attachment.
• Setthedesiredinclinationangleandtightenthethumbscrewswelltotheassemblybracket.
9. DMX Connection
You can operate a maximum of 32 devices in a DMX chain without overloading the controller.
The maximum total length of the DMX chain should not exceed 500 m.
Use of XLR microphone cables may cause interferences in the DMX signal transmission. In this
case, please use special DMX high-frequency cables.
a) Connection of a DMX Controller
Only connect the device to a DMX controller with a DMX-512 protocol.
• ConnecttheportDMXIN(1)withtheoutputoftheDMXcontroller.
• Thecontrollermusthave1or7freecontrolchannelsdependingonoperatingmode.
• ConnectDMXOUT(2)withtheDMXinputofthesubsequentdevice.
• ProceedaccordinglywithallotherdevicesoftheDMXchain.
• IftheeectlightisthelastortheonlydeviceintheDMXchain,insertanXLRplugwitha120ohm/0.25W
terminating resistor into the DMX OUT (2) socket (between Pin2 and Pin3).