User manual

31
• Theeectlightcanbesetuporinstalledwiththeenclosedmountingbracket.
• Ifyoudonotwanttousethedevicestandingbutmountitonasuitabletraversesystem,attachtheeect
light with the included mounting bracket and a suitable traverse clamp that is available separately.
• Forthis,usethemountingbrackettoinstallthetwoscrewsatthebottomplateandattachtheeectlight
to the traverse system with a suitable traverse clamp. Use only assembly material suitable for the type of
assembly and for bearing the eect light load.
• Theassemblymustneverswingfreely.
• Additionallysecuretheinstallationwithasuitablesafetyrestraintcableorasafetynet.Thesafetyreten-
tion rope or the net must be designed to support the eect light in the event of failure of the main support
system independently of the main attachment.
• Makesurethattheprojectorheadoftheeectlightbeamercanmovefreely;itmaynothitontoanything
or be blocked.
9. DMX Connection
You can operate a maximum of 32 devices in a DMX chain without overloading the controller.
The maximum total length of the DMX chain should not exceed 500 m.
Use of XLR microphone cables may cause interferences in the DMX signal transmission. In this
case, please use special DMX high-frequency cables.
a) Connection of a DMX Controller
Only connect the device to a DMX controller with a DMX-512 protocol.
• ConnecttheportDMXINwiththeoutputoftheDMXcontroller.
• Thecontrollermusthaveupto9or11freecontrolchannelsdependingontheoperatingmode.
• ConnectDMXOUTwiththeDMXinputofthesubsequentdevice.
• ProceedaccordinglywithallotherdevicesoftheDMXchain.
• IftheeectlightisthelastortheonlydeviceintheDMXchain,insertanXLRplugwitha120ohm/0.25W
terminating resistor into the DMX OUT socket (between Pin2 and Pin3).