User manual
33
Restart
After comprehensive changes to the configuration, the moving head may need to be restarted. For this,
perform the following steps.
• Press MODE/ESC (1) repeatedly until rESt appears.
• Press the ENTER button (4) to confirm your input.
• The internal controller restarts the moving head.
Reset to factory settings
At function interferences or to load the factory settings again, the device can be reset to factory settings.
• Press MODE/ESC (1) repeatedly until LoAd appears.
• Press the ENTER button (4) to confirm your input.
• The internal controller reloads the factory settings and restarts the moving head.
• Then the device starts in DMX mode. The display shows d001 (DMX start address = 001).
c) Operating Modes without DMX-Controller
• Press MODE/ESC (1) repeatedly until nASL, nAFA, nStS, nStc or SLAu appears.
• Select the desired standalone operating mode with the buttons UP (2) or DOWN (3) and confirm your
input with the button ENTER (4).
nASL = standalone mode at low speed
• The display indicates SLoU.
• The movements and light eects are executed at low speed.
nAFA = standalone mode at low speed
• The display indicates FASt.
• The movements and light eects are executed at high speed.
nStS = Sound-to-Light mode
• The display indicates SrUn.
• In Sound-to-Light mode, the moving head reacts to the music signals that are detected by the integrated
microphone. This causes the moving head to generate a light show in time to the music.
nStc = Automatic mode
• The display indicates crUn.
• The light eects are controlled by the integrated controller.