User manual
30
Menu Overview
Display Option Explanation
Addr A001-A512 DMX address setting
5CH-12CH Selection of the DMX operating mode (channel number)
SOUN Sound-to-Light Mode
AUtO SLou Automatic mode slow
FASt Automatic mode fast
NAnU P000-P255 Setting the position PAN
t000-t255 Setting the position TILT
r000-r255 Brightness red
G000-G255 Brightness green
b000-b255 Brightness blue
rPAN NO-YES Reversal of the direction of rotation for PAN
rtLt NO-YES Reversal of the direction of rotation for TILT
rSEt NO-YES Reset
LoAd NO-YES Resetting to factory settings
dISP NO-YES Reversal of the display
vEr Display of the Firmware Version
b) Use with DMX Controller
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identified by the
controller. This DMX starting address specifies the first DMX channel to which the eect light responds.
The remaining control channels come after this first DMX channel (DMX starting address).
The eect light requires 5 or 12 DMX channels depending on DMX operating mode.
Setting the DMX operating mode (channel number)
• Press MODE/ESC (1) repeatedly until Addr appears.
• Push the button ENTER (4) until 5CH or 12CH appears.
• Use the buttons UP (2) or DOWN (3) to select the desired DMX operating mode.
5CH = 5 channel DMX mode
12CH = 12-channel DMX operation
• Press the ENTER button (4) to confirm your input.