User manual
29
10. Mains Connection
The mains socket to which the eect light is connected must be close to the device and easily
accessible to quickly separate the device from the mains voltage in case of an error.
Do not let the mains cable come into contact with other cables.
Be careful when handling mains cables and mains connections. Mains voltage may cause po-
tentially fatal electric shock.
Make sure that no cables are lying around openly. Install cables professionally to prevent acci
-
dents.
Before plugging in the mains plug, ensure that the device voltage indicated at the eect light
corresponds to the available mains voltage. Do not connect the device if the indication does
not correspond to the available mains voltage. Incorrect supply voltage may lead to irreparable
damage to the device and danger to the user.
• Connect the low-voltage connector of the mains cable to the mains socket of the device.
• Plug the mains plug of the mains line into a grounded socket.
• Once the device has been connected to the mains voltage, it performs a reset and takes up operation
again.
11. Operation
a) General Operation
The eect light can be controlled with the integrated controller or with an external DMX controller. Additi-
onally, it can be used as a master device with integrated controller to control other connected eect lights
synchronously in master-slave operation, or as slave device via the controller of another eect light.
The settings are made in the menu via the display and the function buttons MODE/ESC (1), UP (2),
DOWN (3) and ENTER (4).
MODE/ESC (1) Selection of the programme functions
UP (2) and DOWN (3) Navigation and value selection within the menu
ENTER (4) Selection of submenus