User manual
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent the
technical status at the time of printing.
© Copyright 2015 by Conrad Electronic SE. V2_0915_02-LS
Installation and connection
Implicitly observe the correct order of all installation steps. Only at the nal
step may the mains plug be connected to the wall socket.
If connecting several luminaires in series, observe the maximum permissible
number of luminaires:
Item no. 1305414: max. 22 luminaires in series
Item no. 1305415: max. 12 luminaires in series
• Select a suitable installation location and draw a horizontal line. Mark the position
of the 2 bore holes on that line.
When drilling or tightening screws, make sure not to damage any cables,
wires or pipes located underneath the surface.
• Drill the two holes and insert the dowels.
• Attach the two retaining clips using the screws provided. Do not over tighten the
screws, but leave some clearance for ne adjustment.
• Insert the product into the retaining clips. Make sure the product sits securely and
cannot fall down.
• Install further luminaires as described above.
The luminaires can be inserted to one another or be connected using the
short cable provided. To do so, remove the protective cap from the output
(except for the last luminaire if connected in series).
• Connect the mains cable to the luminaire (or rst luminaire if connected in series).
• Connect the power plug to a common household power outlet.
Operation
• Use the toggle switch to turn the luminaire on/o.
• Luminaires connected in series can be switched individually.
Maintenance and cleaning
Never use aggressive or abrasive cleaning agents, rubbing alcohol or other
chemical solvents, as those can damage the housing or even aect the
operation of the product.
• This product does not require maintenance. Maintenance or repairs may be carried
out by a professional only.
• The LED illuminants are integral and cannot be replaced.
• Switch o the product before cleaning, disconnect the mains plug from the wall
socket, and let the product cool down to room temperature.
• Use a clean, soft, dry cloth to clean the product. You can easily remove dust using a
clean, soft brush or a vacuum cleaner.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste.
At the end of its service life, dispose of the product according to the
relevant statutory regulations.
You thus full your statutory obligations and contribute to the protection of
the environment.
Technical data
Operating voltage................................220 – 240 V/AC, 50/60 Hz
Power consumption............................8 W (Item no. 1305414)
12 W (Item no. 1305415)
Illuminant .............................................. 77 x LED (Item no. 1305414)
112 x LED (Item no. 1305415)
Luminous ux ....................................... 650 lm (Item no. 1305414)
900 lm (Item no. 1305415)
Colour temperature.............................4000 K
Protection type ....................................IP20
Protection class ..................................II
Cable length .........................................1.8 m
Operating conditions ..........................-25 to +45 ºC, 20 – 70 % RH
Storage conditions..............................-25 to +40 ºC, 20 – 70 % RH
Dimensions (W x H x D)......................518 x 28 x 35 mm (Item no. 1305414)
889 x 28 x 35 mm (Item no. 1305415)
Weight ...................................................approx. 320 g (Item no. 1305414)
approx. 420 g (Item no. 1305415)