User manual

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent the
technical status at the time of printing.
© Copyright 2015 by Conrad Electronic SE. V3_0115_02-ETS-Mkd
Troubleshooting
Problem Cause Solution
The pump does not pump
water.
Air in the pump or hose.
Switch the pump o and
on again (disconnect and
re-connect the power
adapter). It might be
necessary to repeat this
procedure several times
during rst time use.
Water inlet of the pump
is dirty.
Clean the pump (see
following chapter).
Unsteady water ow.
Not enough water in the
tank.
Add more water.
Maintenance and cleaning
a) General
• This product does not require maintenance. There are no components located
inside the product you need to maintain. Never open/dismantle the product.
• Clean the Buddha gurine with a damp cloth if necessary. Use a few drops of a mild
detergent to remove heavier staining. Never use any aggressive cleaning agents or
chemical solutions.
b) Cleaning the pump
• Disconnect the power adapter from the mains.
• Disconnect the long cable of the pump from the power adapter.
• Disconnect the cable of the LED ring from the short cable of the pump.
• Disconnect the hose from the LED ring and pump.
• Clean the pump and the hose under running water. Make sure the cable connections
do not get damp or wet.
• Never use any aggressive cleaning agents or chemical solutions.
c) Changing the water
• In order to keep the product in good condition, change the water every 3 days.
• Pour out the water through the opening in the back.
• It is recommended to use distilled or ltered (puried) water to achieve best
possible performance.
Storage
• Pour out the water through the opening in the back.
• Store the product in a dry and frost-free room once the temperatures are close to
freezing point.
• Use the product again, only when you are certain the water cannot freeze.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste.
At the end of its service life, dispose of the product according to the
relevant statutory regulations.
You thus full your statutory obligations and contribute to the protection of
the environment.
Technical data
Operating voltage................................230 – 240 V/AC, 50 Hz (power adapter)
12 V/AC, 50 Hz (pump)
Power consumption............................7 W (pump)
0.75 W (LED)
Protection type ....................................IPX8 (pump)
IP44 (power adapter)
Protection class ..................................III (pump)
II (power adapter)
Number of LEDs...................................6
LED colour temperature ..................... 6000 – 7000 K
Material ................................................polyresin, breglass
Operating conditions ..........................+1 to +35 ºC, 0 – 90 % RH
Storage conditions..............................+1 to +35 ºC, 0 – 90 % RH
Dimensions (W x H x D)......................585 x 570 x 480 mm (item no. 1275878)
465 x 760 x 425 mm (item no. 1275879)
Weight ...................................................9 kg