User's Manual

ZcoRE3-2400_User_Manual_V1.0
Module Interface 3.
3.1
The module interface includes the power input (3.3 V), power output (3.3 V), configuration
button signal, serial ports (CMOS 3.3 V), A/D, I
2
C, test signal, JTAG and digital I/O, etc. These
are integrated on a dual row, 20 pins per row, 1.27 mm pitch connector (J1). Refer to Table 3.1
for a detailed pin definition.
REnex can provide an evaluation kit for the ZcoRE3-2400/ZcoRE3 (20)-2400 module, which
includes 4 modules and 4 evaluation mother board (refer to the ZcoRE3-2400 evaluation kit user
manual for more details). The module interface and other important IO are provided on the
module evaluation board.
The users can also design their own application board with the required module interface. Two of
the most important interfaces are the pin header interface and the RF interface described below.
1.27 mm Pin Header Interface
The pin header interface of the ZcoRE3-2400/ZcoRE3(20)-2400 is designed using a dual row
1.27 mm socket with a total of 40 pins. The JVE 21N21040-40M00B-01G-2.2/5.8 will be
mounted on when the module is shipped. Refer to the JVE datasheet for detailed socket
information.
Users that want to use a different socket can also request that the pin header is not mounted.
These users must make sure to match the PCB design of the interface. The following is a general
drawing of the JVE socket (dimensions in mm).
To match the ZcoRE3-2400/ZcoRE3(20)-2400 interface using the JVE pin header, JVE
22p8702-40M00B-01G-4.5 is an appropriate housing. The following is a general drawing of the
JVE housing (dimensions in mm).
3