User manual

 iSYSTEM, September 2014 2/23
1 Introduction
The Renesas V850E2/Fx4 ActiveGT POD is built from the iC3000/ActiveGT platform from
iSYSTEM and a special V850E2/Fx4 emulation POD produced by Renesas. The two parts
are connected with a wide flex cable that carries JTAG debug and Nexus trace signals.
Debug Features
 Execution breakpoints
 Access breakpoints
 Real-time memory access
 Trace
 Profiler
 Execution Coverage
 Flash Security and Mask Options programming
1.1 Power Sequencing
For a correct emulator operation a prescribed power sequence must be followed:
 At Power On the emulator must be switched on first, and then the target. In an automated test
environments the delay in between should be about 300ms or more.
 At Power Off, first switch the target off, then the emulator.