User manual

 iSYSTEM, September 2014 19/23
Example 3: The trace will start recording (instructions and data accesses) after the function
Type_Simple() is executed for the fifth time.
Let‘s configure a new trigger called e.g. ‘Trigger 1’.
Reuse the settings from the previous example. All remains the same except that Execution Watchpoint
1 is now configured for the sequencer respectively SW4 state of the sequencer instead for the trigger.
The user can configure a sequence of up to 4 states (SW1-SW4) in the ‘Sequencer’ field. Additionally,
enable the counter, which connects it to the output of the sequencer and set its value to 5.
Example 3 Trigger Settings
Next, open the Qualifier pane in order to enable also a data access recording.