Hardware manual

2.9.5 Switch & LED
They are connected to port terminals of the CPU.
SW1
LED1
LED2
LED3
LED4
Power LED
・ P24_12, P24_13, and P24_14 can be used for the switch inputs.
It connects the pull-up resistor with built-in CPU. Set the switch to OFF to read High
and to ON to read Low.
・ P24_8, P24_9, P24_10, and P24_11 can be connected to LED. Set the switch ON and
output Low from the port to light the LED.
・ SW1-8 is power indicator. Power LED is off when power is OFF.
SW1 Connect to
P24_12/TAUC7O9 1 GND
P24_13/TAUC7O10 2 GND
P24_14/ETH0COL/TAUC7O13 3 GND
P24_8/TAUC7O1 4 LED1
P24_9/TAUC7O2 5 LED2
P24_10/TAUC7O5 6 LED3
P24_11/TAUC7O6 7 LED4
5V Power Supply 8 Power LED
- 26 -