Datasheet

78K0/Ix2 CHAPTER 25 FLASH MEMORY
R01UH0010EJ0500 Rev.5.00 662
Feb 28, 2012
25.7 Processing Time for Each Command When PG-FP5 Is Used (Reference)
The following table shows the processing time for each command (reference) when the PG-FP5 is used as a dedicated
flash memory programmer.
Table 25-9. Processing Time for Each Command When PG-FP5 Is Used (Reference) (1/2)
(1) Products with internal ROMs of the 4 KB: PD78F0740, 78F0750
Command of PG-FP5 Port: UART-Internal-OSC (Internal high-speed oscillation clock (fIH: 8 MHz (typ.)),
Speed: 500,000 bps
Signature 0.5 s (typ.)
Blankcheck 0.5 s (typ.)
Erase 0.5 s (typ.)
Program 1 s (typ.)
Verify 1 s (typ.)
E.P.V 1 s (typ.)
Checksum 0.5 s (typ.)
Security 0.5 s (typ.)
(2) Products with internal ROMs of the 8 KB: PD78F0741, 78F0743, 78F0745, 78F0751, 78F0753, 78F0755
Command of PG-FP5 Port: UART-Internal-OSC (Internal high-speed oscillation clock (fIH: 8 MHz (typ.)),
Speed: 500,000 bps
Signature 0.5 s (typ.)
Blankcheck 0.5 s (typ.)
Erase 1 s (typ.)
Program 1.5 s (typ.)
Verify 1 s (typ.)
E.P.V 1.5 s (typ.)
Checksum 0.5 s (typ.)
Security 0.5 s (typ.)
Caution When executing boot swapping, do not use the E.P.V. command with the dedicated flash memory
programmer.