Datasheet

78K0/Ix2 CHAPTER 18 INTERRUPT FUNCTIONS
R01UH0010EJ0500 Rev.5.00 576
Feb 28, 2012
18.3 Registers Controlling Interrupt Functions
The following 7 types of registers are used to control the interrupt functions.
 Interrupt request flag registers (IF0L, IF0H, IF1L, IF1H)
 Interrupt mask flag registers (MK0L, MK0H, MK1L, MK1H)
 Priority specification flag registers (PR0L, PR0H, PR1L, PR1H)
 Port alternate switch control registers (MUXSEL)
 External interrupt rising edge enable registers 0, 1 (EGPCTL0, EGPCTL1)
 External interrupt falling edge enable registers 0, 1 (EGNCTL0, EGNCTL1)
 Program status word (PSW)
Table 18-2 shows a list of interrupt request flags, interrupt mask flags, and priority specification flags corresponding to
interrupt request sources.
Table 18-2. Flags Corresponding to Interrupt Request Sources
Interrupt Request Flag Interrupt Mask Flag Priority Specification FlagIY2 IA2 IB2
16
pins
20
pins
30
pins
32
pins
Interrupt
Source
Register Register Register
   
INTLVI LVIIF IF0L LVIMK MK0L LVIPR PR0L
   
INTP0 PIF0 PMK0 PPR0
   
INTP1 PIF1 PMK1 PPR1
   
INTP2 PIF2 PMK2 PPR2
   
INTP3 PIF3 PMK3 PPR3
   
INTP4 PIF4 PMK4 PPR4
   
INTP5 PIF5 PMK5 PPR5
   
INTSRE6 SREIF6 SREMK6 SREPR6
   
INTSR6 SRIF6 IF0H SRMK6 MK0H SRPR6 PR0H
   
INTST6 STIF6 STMK6 STPR6
   
INTCSI11 CSIIF11 CSIMK11 CSIPR11
   
INTTMH1 TMIFH1 TMMKH1 TMPRH1
   
INTTMX0 TMIFX0 TMMKX0 TMPRX0
   
INTTMX1 TMIFX1 TMMKX1 TMPRX1
   
INTTM000 TMIF000 TMMK000 TMPR000
   
INTTM010 TMIF010 TMMK010 TMPR010
   
INTAD ADIF IF1L ADMK MK1L ADPR PR1L
   
INTTM51
Note
TMIF51 TMMK51 TMPR51
   
INTCMP0 CMPIF0 CMPMK0 CMPPR0
   
INTCMP1 CMPIF1 CMPMK1 CMPPR1
   
INTCMP2 CMPIF2 CMPMK2 CMPPR2
   
INTIICA0 IICAIF0 IF1H IICAMK0 MK1H IICAPR0 PR1H
Note When 8-bit timer/event counter 51 is used in the carrier generator mode, an interrupt is generated upon the
timing when the INTTM5H1 signal is generated (refer to Figure 9-13 Transfer Timing).