Datasheet

78K0/Kx2-L CHAPTER 6 16-BIT TIMER/EVENT COUNTER 00
R01UH0028EJ0400 Rev.4.00 247
Sep 27, 2010
Table 6-2. Capture Operation of CR000 and CR010
External Input
Signal
Capture
Operation
TI000 Pin Input
TI010 Pin Input
Set values of ES010 and
ES000
Position of edge to be
captured
Set values of ES110 and
ES100
Position of edge to be
captured
01: Rising
01: Rising
00: Falling
00: Falling
CRC001 = 1
TI000 pin input
(reverse phase)
11: Both edges
(cannot be captured)
CRC001 bit = 0
TI010 pin input
11: Both edges
Capture operation of
CR000
Interrupt signal
INTTM000 signal is not
generated even if value
is captured.
Interrupt signal
INTTM000 signal is
generated each time
value is captured.
Set values of ES010 and
ES000
Position of edge to be
captured
01: Rising
00: Falling
TI000 pin input
Note
11: Both edges
Capture operation of
CR010
Interrupt signal
INTTM010 signal is
generated each time
value is captured.
Note The capture operation of CR010 is not affected by the setting of the CRC001 bit.
Caution To capture the count value of the TM00 register to the CR000 register by using the phase reverse to
that input to the TI000 pin, the interrupt request signal (INTTM000) is not generated after the value
has been captured. If the valid edge is detected on the TI010 pin during this operation, the capture
operation is not performed but the INTTM000 signal is generated as an external interrupt signal. To
not use the external interrupt, mask the INTTM000 signal.
Remark CRC001: Refer to 6.3 (2) Capture/compare control register 00 (CRC00).
ES110, ES100, ES010, ES000: Refer to 6.3 (4) Prescaler mode register 00 (PRM00).