Datasheet

ManualsBrandsRENESAS ManualsMicrocontrollers, Microprocessors & QuartzesEmbedded microcontroller SSOP 30 8-Bit 10 MHz I/O number 21

78K0/Kx2-L CHAPTER 1 OUTLINE

R01UH0028EJ0400 Rev.4.00 10

Sep 27, 2010

(3) 32-pin plastic WQFN (5x5) (2/2)

AMP0-

Note

, AMP0+

Note

: Amplifier Input RESET : Reset

AMP0OUT

Note

: Amplifier Output RxD6 : Receive Data

PGAIN

Note

: Programmable Gain SCK11 : Serial Clock Input/Output

Amplifier Input SCLA0 : Serial Clock Input/Output

ANI0 to ANI10 : Analog Input SDAA0 : Serial Data Input/Output

REF : Analog Reference Voltage SI11 : Serial Data Input

SS : Analog Ground SO11 : Serial Data Output

EXCLK : External Clock Input

SSI11

: Serial Interface Chip

(Main System Clock) Select Input

IC0 : Internally Connected TI000, TI010 : Timer Input

INTP0, INTP2 to INTP5 : External Interrupt Input TO00, TOH1 : Timer Output

P01, P02 : Port 0

TOOLC0, TOOLC1

: Clock Input for Tool

P20 to P27 : Port 2

TOOLD0, TOOLD1

: Data Input/Output for Tool

P31 to P37 : Port 3 TxD6 : Transmit Data

P60, P61 : Port 6 V

DD : Power Supply

P70 to P72 : Port 7 V

SS : Ground

P121, P122, P125 : Port 12 X1, X2 : Crystal Oscillator

REGC : Regulator Capacitance (Main System Clock)

Note

PD78F0565, 78F0566, 78F0567 (products with operational amplifier) only

Cautions 1. Connect directly IC0 (Internally Connected) to V

SS .

2. V

SS functions alternately as the ground potential of the A/D converter. Be sure to connect VSS to

a stabilized GND (= 0 V).

3. Connect the REGC pin to V

SS via a capacitor (0.47 to 1

F).

4. ANI0/P20/AMP0-, ANI1/P21/AMP0OUT/PGAIN, ANI2/P22/AMP0+, ANI3/P23 to ANI7/P27, and

ANI8/P70 to ANI10/P72 are set in the analog input mode after release of reset.

5. RESET/P125 immediately after release of reset is set in the external reset input.

6. Set P30 to output mode (PM30 = 0) by using software after release of reset.

Remark Functions in parentheses ( ) in the figure above can be assigned by setting the port alternate switch control

<R>