Datasheet

V850ES/JG3-H, V850ES/JH3-H CHAPTER 19 I
2
C BUS
R01UH0042EJ0500 Rev.5.00 Page 885 of 1513
Aug 12, 2011
19.17 Timing of Data Communication
When using I
2
C bus mode, the master device outputs an address via the serial bus to select one of several slave
devices as its communication partner.
After outputting the slave address, the master device transmits the IICSn.TRCn bit, which specifies the data transfer
direction, and then starts serial communication with the slave device.
The shift operation of the IICn register is synchronized with the falling edge of the serial clock pin (SCL0n). The
transmit data is transferred to the SO latch and is output (MSB first) via the SDA0n pin.
Data input via the SDA0n pin is captured by the IICn register at the rising edge of the SCL0n pin.
The data communication timing is shown below.
Remark n = 0 to 2