Datasheet

V850ES/JG3-H, V850ES/JH3-H CHAPTER 11 MOTOR CONTROL FUNCTION
R01UH0042EJ0500 Rev.5.00 Page 632 of 1513
Aug 12, 2011
Cautions 1. The A/D conversion start trigger signal output that is set by the TAB1AT2 and TAB1AT3 bits can be
used only when TAA4 is performing a tuning operation as the slave timer of TAB1. If TAB1 and
TAA4 are not performing a tuning operation, or if a mode other than the 6-phase PWM output
mode is used, the output cannot be guaranteed.
2. The TAB1 signal output is internally used to identify whether the 16-bit counter is counting up or
down. Therefore, enable TOAB10 pin output by clearing the TAB1IOC0.TAB1OL0 bit to 0 and
setting the TAB1IOC0.TAB1OE0 bit to 1.