Datasheet
V850ES/JG3-H, V850ES/JH3-H CHAPTER 33 ELECTRICAL SPECIFICATIONS
R01UH0042EJ0500 Rev.5.00 Page 1410 of 1513
Aug 12, 2011
(TA = 25°C) (2/2)
Parameter Symbol Conditions Ratings Unit
Per pin 4 mA P00 to P05, P20 to P25, P30 to P37
P40 to P42, P50 to P56, P60 to P65
P90 to P915
PCM0 to PCM3, PCS0, PCS2, PCS3
PCT0, PCT1, PCT4, PCT6
PDL0 to PDL15, PDH0 to PDH7
Total of all pins 50 mA
Per pin 4 mA UDMF, UDPF
Total of all pins 8 mA
Per pin 4 mA P10, P11
Total of all pins 8 mA
Per pin 4 mA
Output current, low IOL
P70 to P711
Total of all pins 20 mA
Per pin −4 mA P00 to P05, P20 to P25, P30 to P37
P40 to P42, P50 to P56, P60 to P65
P90 to P915, PCM0 to PCM3, PCS0
PCS2, PCS3, PCT0, PCT1, PCT4
PCT6, PDL0 to PDL15, PDH0 to PDH7
Total of all pins −50 mA
Per pin −4 mA UDMF, UDPF
Total of all pins −8 mA
Per pin −4 mA P10, P11
Total of all pins −8 mA
Per pin −4 mA
Output current, high IOH
P70 to P711
Total of all pins −20 mA
In normal operation −40 to +85 °C Operating ambient
temperature
TA
In flash memory programming −40 to +85 °C
Storage temperature Tstg −40 to +125 °C
Cautions 1. Do not directly connect the output (or I/O) pins of IC products to each other, or to VDD, VCC, and GND.
Open-drain pins or open-collector pins, however, can be directly connected to each other. Direct
connection of the output pins between an IC product and an external circuit is possible, if the output
pins can be set to the high-impedance state and the output timing of the external circuit is designed
to avoid output conflict.
2. Product quality may suffer if the absolute maximum rating is exceeded even momentarily for any
parameter. That is, the absolute maximum ratings are rated values at which the product is on the
verge of suffering physical damage. Therefore the product must be used under conditions that
ensure that the absolute maximum ratings are not exceeded.
The ratings and conditions indicated for DC characteristics and AC characteristics represent the
quality assurance range during normal operation.
Remark Unless specified otherwise, the characteristics of alternate-function pins are the same as those of port pins.