Datasheet
V850ES/JG3-H, V850ES/JH3-H CHAPTER 33 ELECTRICAL SPECIFICATIONS
R01UH0042EJ0500 Rev.5.00 Page 1409 of 1513
Aug 12, 2011
CHAPTER 33 ELECTRICAL SPECIFICATIONS
33.1 Absolute Maximum Ratings
(T
A = 25°C) (1/2)
Parameter Symbol Conditions Ratings Unit
VDD VDD = EVDD = UVDD = AVREF0 = AVREF1 −0.5 to +4.6 V
EVDD VDD = EVDD = UVDD = AVREF0 = AVREF1 −0.5 to +4.6 V
UVDD VDD = EVDD = UVDD = AVREF0 = AVREF1 −0.5 to +4.6 V
AVREF0 VDD = EVDD = UVDD = AVREF0 = AVREF1 −0.5 to +4.6 V
AVREF1 VDD = EVDD = UVDD = AVREF0 = AVREF1 −0.5 to +4.6 V
VSS VSS = AVSS −0.5 to +0.5 V
Supply voltage
AV
SS VSS = AVSS −0.5 to +0.5 V
VI1 P60 to P65, P90 to P915, PCM0, PCM1, PCS0
PCS2, PCS3, PCT0, PCT1, PCT4, PCT6
PDL0 to PDL15, PDH0 to PDH7, RESET, FLMD0
−0.5 to EV
DD + 0.5
Note 1
V
VI2 UDMF, UDPF −0.5 to UVDD + 0.5
Note 1
V
VI3 P10, P11 −0.5 to AVREF1 + 0.5
Note 1
V
VI4 X1, X2, XT1, XT2 −0.5 to VRO
Note 2
+ 0.5
Note 1
V
Input voltage
V
I5 P00 to P05, P20 to P25, P30 to P37, P40 to P42
P50 to P56, PCM2, PCM3
−0.5 to +6.0 V
Analog input voltage VIAN P70 to P711 −0.5 to AVREF0 + 0.5
Note 1
V
Cautions 1. Do not directly connect the output (or I/O) pins of IC products to each other, or to VDD, VCC, and GND.
Open-drain pins or open-collector pins, however, can be directly connected to each other. Direct
connection of the output pins between an IC product and an external circuit is possible, if the output
pins can be set to the high-impedance state and the output timing of the external circuit is designed
to avoid output conflict.
2. Product quality may suffer if the absolute maximum rating is exceeded even momentarily for any
parameter. That is, the absolute maximum ratings are rated values at which the product is on the
verge of suffering physical damage. Therefore the product must be used under conditions that
ensure that the absolute maximum ratings are not exceeded.
The ratings and conditions indicated for DC characteristics and AC characteristics represent the
quality assurance range during normal operation.
Notes 1. Be sure not to exceed the absolute maximum ratings (MAX. value) of each supply voltage.
2. On-chip regulator output voltage (2.5 V (TYP.))
Remark Unless specified otherwise, the characteristics of alternate-function pins are the same as those of port pins.