Datasheet

V850ES/JG3-H, V850ES/JH3-H CHAPTER 32 ON-CHIP DEBUG FUNCTION
R01UH0042EJ0500 Rev.5.00 Page 1396 of 1513
Aug 12, 2011
Table 32-4. Wiring Between V850ES/JH3-H and MINICUBE2
Pin Configuration of MINICUBE2 (QB-MINI2) With CSIF0-HS With CSIF3-HS With UARTC0
Signal Name I/O Pin Function Pin Name Pin
No.
Pin Name Pin
No.
Pin Name Pin
No.
SI/RXD Input Pin to receive commands and data from
V850ES/JH3-H
P41/SOF0 30 P911/SOF3 67 P30/TXDC0 37
SO/TXD Output Pin to transmit commands and data to
V850ES/JH3-H
P40/SIF0 29 P910/SIF3 66 P31/RXDC0 31
SCK Output Clock output pin for 3-wire serial
communication
P42/SCKF0 31 P912/SCKF3 68 Not needed
−
CLK
Note
Output Clock output pin to V850ES/JH3-H Not
needed
Note
−
Not
needed
Note
−
Not
needed
Note
−
RESET_OUT Output Reset output pin to V850ES/JH3-H RESET 18 RESET 18 RESET 18
FLMD0 Output Output pin to set V850ES/JH3-H to
debug mode or programming mode
FLMD0 12 FLMD0 12 FLMD0 12
FLMD1 Output Output pin to set programming mode PDL5/FLMD1 103 PDL5/FLMD1 103 PDL5/FLMD1 103
HS Input Handshake signal for CSI0 + HS
communication
P913 69 P913 69 Not needed
−
VSS 15,
45,
84,
106
VSS 15,
45,
84,
106
VSS 15,
45,
84,
106
GND
−
Ground
AV
SS 2 AVSS 2 AVSS 2
RESET_IN Input Reset input pin on the target system
Note It is used as the clock output of the flash programmer for MINICUBE2. For details, refer to CHAPTER 31 FLASH
MEMORY.