Datasheet
V850ES/JG3-H, V850ES/JH3-H CHAPTER 32 ON-CHIP DEBUG FUNCTION
R01UH0042EJ0500 Rev.5.00 Page 1388 of 1513
Aug 12, 2011
CHAPTER 32 ON-CHIP DEBUG FUNCTION
The on-chip debug function of the V850ES/JG3-H and V850ES/JH3-H can be implemented by the following two
methods.
• Using the DCU (debug control unit)
On-chip debug function is implemented by the on-chip DCU in the V850ES/JG3-H and V850ES/JH3-H, with using the
DRST, DCK, DMS, DDI, and DDO pins as the debug interface pins.
• Not using the DCU
On-chip debug function is implemented by MINICUBE2 or the like, using the user resources, instead of the DCU.
The following table shows the features of the two on-chip debug functions.
Table 32-1. On-Chip Debug Function Features
Debugging Using DCU Debugging Without Using DCU
Debug interface pins DRST, DCK, DMS, DDI, DDO
• When UARTC0 is used
RXDC0, TXDC0
• When CSIF0 is used
SIF0, SOF0, SCKF0, HS (P913)
• When CSIF3 is used
SIF3, SOF3, SCKF3, HS (P913)
Securement of user resources Not required Required
Hardware break function 2 points 2 points
Internal ROM area 4 points 4 points
Software break
function
Internal RAM area 2000 points 2000 points
Real-time RAM monitor function
Note 1
Available Available
Dynamic memory modification (DMM)
function
Note 2
Available Available
Mask function
Reset, NMI, INTWDT2, HLDRQ,
WAIT
RESET pin
ROM security function 10-byte ID code authentication 10-byte ID code authentication
Hardware used NINICUBE, etc. NINICUBE2, etc.
Trace function Not supported. Not supported.
Debug interrupt interface function
(DBINT)
Not supported. Not supported.
Notes 1. This is a function which reads out memory contents during program execution.
2. This is a function which rewrites RAM contents during program execution.