Datasheet

V850ES/JG3-H, V850ES/JH3-H CHAPTER 31 FLASH MEMORY
R01UH0042EJ0500 Rev.5.00 Page 1369 of 1513
Aug 12, 2011
Table 31-7. Wiring of V850ES/JH3-H Flash Writing Adapters (1/4)
Pin No. Pin Name Recommended Connection
1 AVREF0 Connect to VDD pin of the programmer
2 AVSS Connect to GND pin of the programmer
3 P10/ANO0 -
4 P11/ANO1 -
5 AVREF1 Connect to VDD pin of the programmer
6 P02/NMI -
7 P03/INTP02/ADTRG/UCLK -
8 P00/INTP00 -
9 P01/INTP01
-
10 PCM2/HLDAK
-
11 PCM3/HLDRQ
-
12 FLMD0 Connect to FLMD0 (output) pin of the programmer
13 VDD Connect to VDD pin of the programmer
14 REGC Connect the REGC pin to GND via 4.7 μ F capacitor
15 VSS Connect to GND pin of the programmer
16 X1 Connect to 3 to 6 MHz Resonator
17 X2 Connect to 3 to 6 MHz Resonator
18 RESET Connect to RESET (output) pin of the programmer
19 XT1 Connect to GND pin of the programmer
20 XT2 -
21 UDMF -
22 UDPF -
23 UVDD Connect to VDD pin of the programmer
24 P04/INTP03 -
25 P05/INTP04 -
26 P04/INTP03 -
27 P05/INTP04 -
28 P25/INTP06 -
29 P40/SIF0/TXDC4/SDA01
When CSI (CSIF0) is used : connect to SO (output) pin of the
programmer
When CSI (CSIF0)is not used : pull-down
Note
30 P41/SOF0/RXDC4/SCL01
When CSI (CSIF0)is used : connect to SI (input) pin of the
programmer
When CSI (CSIF0)is not used : pull-down
Note
31 P42/SCKF0/INTP10
When CSI(CSIF0)is used : connect to SCK (output) pin of the
programmer
When CSI (CSIF0)is not used : pull-down
Note
32 P20/TIAB03/KR2/TOAB03/RTP02 -
33 P21/SIF2/TIAB00/KR3/TOAB00/RTP03 -
Note Independently connect to EVSS or VDD via a resistor.