Datasheet

V850ES/JG3-H, V850ES/JH3-H CHAPTER 31 FLASH MEMORY
R01UH0042EJ0500 Rev.5.00 Page 1364 of 1513
Aug 12, 2011
Table 31-6. Wiring of V850ES/JG3-H Flash Writing Adapters (1/3)
Pin No. Pin Name Recommended Connection
1 AVREF0 Connect to VDD pin of the programmer
2 AVSS Connect to GND pin of the programmer
3 P10/ANO0 -
4 P11/ANO1 -
5 AVREF1 Connect to VDD pin of the programmer
6 P02/NMI -
7 P03/INTP02/ADTRG/UCLK -
8 FLMD0 Connect to FLMD0 (output) pin of the programmer
9 VDD Connect to VDD pin of the programmer
10 REGC Connect the REGC pin to GND via 4.7 μ F capacitor
11 VSS Connect to GND pin of the programmer
12 X1 Connect to 3 to 6 MHz Resonator
13 X2 Connect to 3 to 6 MHz Resonator
14 RESET Connect to RESET (output) pin of the programmer
15 XT1 Connect to GND pin of the programmer
16 XT2 -
17 UDMF -
18 UDPF -
19 UVDD Connect to VDD pin of the programmer
20 P04/INTP03 -
21 P05/INTP04 -
22 P40/SIF0/TXDC4/SDA01
When CSI (CSIF0) is used : connect to SO (output) pin of the
programmer
When CSI (CSIF0)is not used : pull-down
Note
23 P41/SOF0/RXDC4/SCL01
When CSI (CSIF0)is used : connect to SI (input) pin of the
programmer
When CSI (CSIF0)is not used : pull-down
Note
24 P42/SCKF0/INTP10
When CSI(CSIF0)is used : connect to SCK (output) pin of the
programmer
When CSI (CSIF0)is not used : pull-down
Note
25 P30/TXDC0/SOF4/INTP07
When UART (UARTD0) is used : connect to RxD (input) pin of the
programmer
When UART (UARTD0) is not used : pull-down
Note
26 P31/RXDC0/SIF4/INTP08
When UART (UARTD0) is used : connect to TxD (output) pin of
the programmer
When UART (UARTD0) is not used : pull-down
Note
27 P32/ASCKC0/SCKF4/TIAA00/TOAA00 -
28 P33/TIAA01/TOAA01/RTCDIV/RTCCL -
29 P34/TIAA10/TOAA10/TOAA1OFF/INTP09 -
30 P35/TIAA11/TOAA11/RTC1HZ -
Note Independently connect to EVSS or VDD via a resistor.