Datasheet

V850ES/JG3-H, V850ES/JH3-H CHAPTER 22 DMA FUNCTION (DMA CONTROLLER)
R01UH0042EJ0500 Rev.5.00 Page 1244 of 1513
Aug 12, 2011
22.6 Transfer Types
As a transfer type, the 2-cycle transfer is supported.
In two-cycle transfer, data transfer is performed in two cycles, a read cycle and a write cycle.
In the read cycle, the transfer source address is output and reading is performed from the source to the DMAC. In the
write cycle, the transfer destination address is output and writing is performed from the DMAC to the destination.
An idle cycle of one clock is always inserted between a read cycle and a write cycle. If the data bus width differs
between the transfer source and destination for DMA transfer of two cycles, the operation is performed as follows.
<16-bit data transfer>
<1> Transfer from 32-bit bus → 16-bit bus
A read cycle (the higher 16 bits are in a high-impedance state) is generated, followed by generation of a write
cycle (16 bits).
<2> Transfer from 16-/32-bit bus to 8-bit bus
A 16-bit read cycle is generated once, and then an 8-bit write cycle is generated twice.
<3> Transfer from 8-bit bus to 16-/32-bit bus
An 8-bit read cycle is generated twice, and then a 16-bit write cycle is generated once.
<4> Transfer between 16-bit bus and 32-bit bus
A 16-bit read cycle is generated once, and then a 16-bit write cycle is generated once.
For DMA transfer executed to an on-chip peripheral I/O register (transfer source/destination), be sure to specify the
same transfer size as the register size. For example, for DMA transfer to an 8-bit register, be sure to specify byte (8-bit)
transfer.
Remark The bus width of each transfer target (transfer source/destination) is as follows.
• On-chip peripheral I/O: 16-bit bus width
• Internal RAM: 32-bit bus width
• External memory: 8-bit or 16-bit bus width