Datasheet

V850ES/JG3 APPENDIX A DEVELOPMENT TOOLS
R01UH0015EJ0300 Rev.3.00 Page 808 of 870
Sep 30, 2010
A.4.3 When using MINICUBE2 QB-MINI2
The system configuration when connecting MINICUBE2 to the host machine (PC-9821 series, PC/AT compatible) is
shown below.
Figure A-4. System Configuration of On-Chip Emulation System
<6>
<5>
<1>
<2> Software
<4> <3>
MINICUBE2
Target system
V850ES/JG3
<1> Host machine PC with USB ports
<2> Software The integrated debugger ID850QB, device file, etc.
Download the device file from the Renesas Electronics website.
http://www2.renesas.com/micro/ja/ods/index.html
<3> USB interface cable USB cable to connect the host machine and MINICUBE. It is supplied with
MINICUBE. The cable length is approximately 2 m.
<4> MINICUBE2
On-chip debug emulator
This on-chip debug emulator serves to debug hardware and software when
developing application systems using the V850ES/JG3. It supports integrated
debugger ID850QB.
<5> 16-pin target cable Cable to connect MINICUBE2 and the target system.
It is supplied with MINICUBE. The cable length is approximately 15 cm.
<6> Target connector (sold separately) Use a 16-pin general-purpose connector with 2.54 mm pitch.
Remark The numbers in the angular brackets correspond to the numbers in Figure A-4.