Datasheet

V850ES/JG3 CHAPTER 19 INTERRUPT/EXCEPTION PROCESSING FUNCTION
R01UH0015EJ0300 Rev.3.00 Page 670 of 870
Sep 30, 2010
19.8 Periods in Which Interrupts Are Not Acknowledged by CPU
An interrupt is acknowledged by the CPU while an instruction is being executed. However, no interrupt will be
acknowledged between an interrupt request non-sample instruction and the next instruction (interrupt is held pending).
The interrupt request non-sample instructions are as follows.
• EI instruction
• DI instruction
• LDSR reg2, 0x5 instruction (for PSW)
• The store instruction for the PRCMD register
• The store, SET1, NOT1, or CLR1 instructions for the following registers.
• Interrupt-related registers:
Interrupt control register (xxICn), interrupt mask registers 0 to 3 (IMR0 to IMR3)
• Power save control register (PSC)
• On-chip debug mode register (OCDM)
Remark xx: Identification name of each peripheral unit (see Table 19-2 Interrupt Control Register (xxICn))
n: Peripheral unit number (see Table 19-2 Interrupt Control Register (xxICn)).
19.9 Cautions
The NMI pin and P02 pin are an alternate-function pin, and function as a normal port pin after being reset. To enable
the NMI pin, validate the NMI pin with the PMC0 register. The initial setting of the NMI pin is “No edge detected”. Select
the NMI pin valid edge using the INTF0 and INTR0 registers.