Datasheet

V850ES/JG3 CHAPTER 15 ASYNCHRONOUS SERIAL INTERFACE A (UARTA)
R01UH0015EJ0300 Rev.3.00 Page 472 of 870
Sep 30, 2010
When reception errors occur, perform the following procedures depending upon the kind of error.
• Parity error
If false data is received due to problems such as noise in the reception line, discard the received data and retransmit.
• Framing error
A baud rate error may have occurred between the reception side and transmission side or the start bit may have
been erroneously detected. Since this is a fatal error for the communication format, check the operation stop in the
transmission side, perform initialization processing each other, and then start the communication again.
• Overrun error
Since the next reception is completed before reading receive data, 1 frame of data is discarded. If this data was
needed, do a retransmission.
Caution If a receive error interrupt occurs during continuous reception, read the contents of the UAnSTR
register must be read before the next reception is completed, then perform error processing.