Datasheet

V850ES/JG3 CHAPTER 15 ASYNCHRONOUS SERIAL INTERFACE A (UARTA)
R01UH0015EJ0300 Rev.3.00 Page 463 of 870
Sep 30, 2010
Figure 15-7. LIN Reception Manipulation Outline
Reception interrupt (INTUAnR)
Edge detection
Capture timer
Disable
Disable
Enable
RXDAn (input)
Enable
Note 2
13 bits
SBF
reception
Note 3
Note 4
Note 1
SF reception
ID reception
Data
transmission
Data
transmission
Note 5
Data transmission
LIN
bus
Wake-up
signal
frame
Sync
break
field
Sync
field
Identifier
field
DATA
field
DATA
field
Check
SUM
field
Notes 1. The wakeup signal is sent by the pin edge detector, UARTAn is enabled, and the SBF reception
mode is set.
2. The receive operation is performed until detection of the stop bit. Upon detection of SBF reception
of 11 or more bits, normal SBF reception end is judged, and an interrupt signal is output. Upon
detection of SBF reception of less than 11 bits, an SBF reception error is judged, no interrupt signal
is output, and the mode returns to the SBF reception mode.
3. If SBF reception ends normally, an interrupt request signal is output. The timer is enabled by an SBF
reception complete interrupt. Moreover, error detection for the UAnSTR.UAnOVE, UAnSTR.UAnPE,
and UAnSTR.UAnFE bits is suppressed and UART communication error detection processing and
UARTAn receive shift register and data transfer of the UAnRX register are not performed. The
UARTAn receive shift register holds the initial value, FFH.
4. The RXDAn pin is connected to TI (capture input) of the timer, the transfer rate is calculated, and the
baud rate error is calculated. The value of the UAnCTL2 register obtained by correcting the baud
rate error after dropping UARTA enable is set again, causing the status to become the reception
status.
5. Check-sum field distinctions are made by software. UARTAn is initialized following CSF reception,
and the processing for setting the SBF reception mode again is performed by software.