Technical information

Section 2 Connecting the Emulator to the User System
Rev. 2.00 Feb. 18, 2009 Page 18 of 94
REJ10J1938-0200
2.2.6 Using the E200F Emulator as a Stand-Alone Unit
If you are using the E200F emulator unit without connecting it to a user system, refer to table 1.3
and table 1.4 in section 1.2, System Configuration, and make connections as shown in figure 2.9
until the EV-chip unit becomes available.
Expansion AUD trace unit
EV-chip unit
Common user-system interface
adaptor cable (board unit)
Common user-system interface
adaptor cable (cable unit)
x 3
User-system interface converter board
When connecting to the user system
When using the emulator as a
stand-alone unit
Figure 2.9 Connecting the E200F Emulator as a Stand-Alone Unit