Hardware manual

e
2
studio 3.1 Release Note
Rev 1.0, Jan 21st, 2015 Page 21
5063
Application
Dependency scanning is not working for assembler file. This is for GCC build plugins.
5083
CubeSuite+
importer/exporter
folder level option is not converted correctly
5110
GDB
For some RX devices the default display of PSW the IPL is displayed wrong. The MSB is not
shown.
5124
Application
Active configuration lost while importing project (which is exported as file system).
5171
CCRX Build plugin
Files included in the Pre-include build options are not analyzed for the pre-processor statement in
the editor. This can give the impression that code is not included in the build when it is.
5179
CubeSuite+
importer/exporter
When CubeSuite+ project imports to e
2
studio, the Build function cannot be performed sometimes.
[Workaround]
Please add the <root folder> to "C/C++ General -> Paths and Symbol -> Source Location"
5201
Application
If you create a project and debug session for a GDB simulator before executing a hardware debug
session it will fail. This is because the debugger support is not unpacked until a hardware debug
session is used.
To work around setup and launch a hardware debug session. You do not actually need hardware
to do this.
5290
Application
When you add a new configuration, please do not specify 'Default Configuration' as a
configuration used as a base.
If you specify the 'Default Configuration', the configuration which does not operate correctly is
created.
5310
RL78 GCC build
plugin
In some case attempting to remove the first section in the GCC linker sections can fail. To rectify
this change the address of the section so it appears further down the list and then a remove
operation should succeed.
5341
CCRX Build plugin
'''Problem'''
Project is cleaned incorrectly before running "Build Configurations > Build All"
at 2nd time after "Build Configurations > Clean All"
'''Workaround'''
Build the Configurations individually.
5372
Application
If you use RX200 series E1/E20, and if you set Data as Trace Type in the Trace Acquisition dialog
even once, Trace view does not show the branch trace information. To show the branch trace
information, please disconnect debugger once and then connect again.
5394
CCRX Build plugin
'''Problem'''
If a source file folder (already included in C option) is deleted, its path was added to Assemble
include.
'''Workaround'''
Remove the path in "Include file directories" will stop the warning.
5456
IAR plugins
In some situations e
2
studio IAR projects are not imported correctly into later versions of the tools.
5467
Application
Settings in the 'Format¦' dialog (Memory view) are not restored.
5530
Application
Indexer settings are not persisted on a project import into e
2
studio.
5531
Application
To use the data access events for RH850 with E1 emulator, the condition "Not Specified" in the
access size is treated as "Byte".