Hardware manual

e
2
studio 3.1 Release Note
Rev 1.0, Jan 21st, 2015 Page 18
2716
GDB server RL78
Before PC events on IECube temporarily hard coded limit of 4.
2762
Application
When using assembly code within a C source file, Codan errors can be observed in the editor.
Even though the project builds successfully.
2859
IAR plugins
When using IAR projects the SFR names (e.g. PIOR1_bit.no1) are not understood correctly in the
editor.
2910
GDB
Registers do not display properly on SH2A 72691.
3389
Application
When debugging files with the same name show source addresses even though it may not be
correct for the file in question. The full file path is not considered just the filename and current
debug context. This can lead to e
2
studio showing addresses unnecessarily.
3410
GDB Server SH
SH2-70865A - clicking step-in when on the closing brace of a function will cause the server to run,
but never respond again.
The only option is to terminate.
3470
Application
When debugging with the RX210 the FPSW register is displayed on the register view. This should
not be the case as the RX210 does not have the FPSW register.
3526
Application
In some cases when using RX with the CCRX compiler the profile view does not display the
source file name and path in the window.
3550
Application
Custom placeholders are not expanded when importing a project from HEW. This is currently
expected behaviour but may be improved in a future version.
3585
Application
The GDB server crashes when an E1 emulator is connected to a debug configuration configured
for the Segger emulator.
3626
Application
Snapshot trace - adding IO register eventpoints increases the data shown in the trace view, but as
they were removed there was no change in the data shown.
3663
Application
With 2 targets connected, clicking between the two debug contexts in the Debug View will update
the source addresses in the open Editor files.
However changing debug context does not seem to get detected if clicking on the top-level of the
debug context rather than on the lower level.
3795
Trace plugin
Saving RX Simulator trace data to the disk can take some time due to the number of records
obtained from the server.
3804
Application
The code generator is not automatically registered when installing into generic Eclipse. Browse to
the CG plugin and then run the batch files that reside in the tools directory.
e.g.
C:\Renesas\e2_studio\eclipse\plugins\com.renesas.cg_1.0.0.201309061659\CodeGenerator\Tool
s
3813
Event points plugin
OA event break event points not breaking at correct addresses on SH7203 (External Flash)
target.
3836
Application
Dependencies with file name that have spaces may cause dependency scanning issues. Where
possible it is better to avoid using spaces in dependency file names.
3847
Application
When using the display as array feature in the expressions window it appears that data can be
skipped and is not updated.