User`s manual

16
5. If an address of a BREAKPOINT cannot be correctly set in the ROM or external flash memory
area, a mark z will be displayed in the [BP] area of the address on the [Source] or
[Disassembly] window by refreshing the [Memory] window, etc. after Go execution. However,
no break will occur at this address. When the program halts with the event condition, the mark
z disappears.
2.2.5 Notes on Setting the [Event Condition] Dialog Box and the BREAKCONDITION_
SET Command
1. When [Go to cursor], [Step In], [Step Over], or [Step Out] is selected, the settings of Event
Condition 3 are disabled.
2. When an Event Condition is satisfied, emulation may stop after two or more instructions have
been executed.
2.2.6 Performance Measurement Function
This MCU does not support the performance measurement function.
2.2.7 Profiling Measurement Function
This MCU does not support the profiling measurement function.