Technical information

Renesas E10A-USB Emulator
Introductory Guide for SH/Tiny (SH7125)
6.3.7 Executing a Program
(1) Select [Reset Go] from the [Debug] menu to execute a program.
Figure 6.32 Executing a Program after a Reset
6.3.8 Break Occurrence
(1) When a break condition is satisfied, the source window shows the program stop position.
Figure 6.33 Screen Showing Break Condition Satisfaction
The yellow arrow points to the program counter location and the corresponding source line is highlighted in yellow.
"EVENT CONDITION 1 for L bus" is displayed as the program stop cause in the [Debug] tab and on the status bar.
REJ06J0007-0100/Rev.1.00 February 2007 Page 33 of 43