Technical information

Renesas E10A-USB Emulator
Introductory Guide for SH/Tiny (SH7125)
(6) The following progress bar will be displayed while the E10A-USB emulator firmware is being written.
Figure 6.10 Starting Setup
Note: Do not turn off the host computer or disconnect the USB cable while setting up the E10A-USB emulator; if
such an attempt is made, the E10A-USB emulator may be damaged.
(7) The following dialog box will appear when E10A-USB emulator has been successfully completed.
Click the [OK] button.
Figure 6.11 Message for Showing Completion of Setup
(8) After E10A-USB emulator setup, the following message will appear. Set DIP switch SW1 to ’1’, disconnect then
reconnect the USB cable, and click the [OK] button.
Figure 6.12 Prompt for Setting E10A-USB Emulator Switch (at Completion)
Notes: 1. Be sure to set DIP switch SW1 to ’1’ except when the setup tool is used.
2. When the emulator is used for a different product group, the firmware should be set up through the setup
tool or license tool for that device group.
To use the setup tool for the new device group, the license tool for the device group should also be installed.
For details on the license tool for adding a device group, refer to section 3.10.2, Setting up the Emulator by
Using the License Tool to Add a Device Group, in the SuperH Family E10A-USB Emulator User's
Manual.
REJ06J0007-0100/Rev.1.00 February 2007 Page 24 of 43