Technical information

Renesas E10A-USB Emulator
Introductory Guide for SH/Tiny (SH7125)
5. Installing the Driver
Before connecting the main unit of the E10A-USB emulator to the host computer, be sure to check that the supplied
software is installed in the computer. Installing the provided software transfers the E10A-USB emulator driver to the
host computer, and the new hardware detection processing will automatically start.
5.1 Wizard for Adding Hardware
(1) Connect the E10A-USB emulator to the host computer through the USB cable.
(2) The [Found New Hardware Wizard] dialog box will appear. Select the [No, not this time] radio button and click
[Next].
Figure 5.1 [Found New Hardware Wizard] Dialog Box
This guide shows an example of the wizard in Windows

XP Service Pack 2 (SP2).
REJ06J0007-0100/Rev.1.00 February 2007 Page 17 of 43
(3) The [Welcome to the Found New Hardware Wizard] dialog box will appear. Select the [Install the software
automatically (Recommended)] radio button and click [Next].
Figure 5.2 Selecting the Driver Software Installation Method