User`s manual

Section 2 Connecting the Emulator to the User System
Rev. 3.00 Oct. 17, 2008 Page 19 of 66
REJ10J1662-0300
2.2.7 Using the E200F Emulator as a Stand-Alone Unit
• If you are using the E200F emulator unit without connecting it to a user system, refer to table
1.3 in section 1.2, System Configuration, and make connections as shown in figure 2.10 until
the EV-chip unit becomes available.
EV-chip unit
User system
interface board
When using the emulator as a
stand-alone unit
When connecting the emulator to
the user system
User system
Figure 2.10 Connecting the E200F Emulator as a Stand-Alone Unit