User`s manual

Section 1 System Configuration
Rev. 3.00 Oct. 17, 2008 Page 7 of 66
REJ10J1662-0300
Notes: 1. When the EV-chip unit is not used, the H-UDI port connector must be installed on the
user system. When designing the user system, refer to section 2.3, Connecting the
Emulator to the User System by Using the H-UDI Port Connector. For this system
configuration, note that the H-UDI and AUD pins of the MCU are occupied by the
emulator.
2. The user system interface board is only used when the emulator is connected to the
user system; it is not required when the emulator system operates alone.