User`s manual

Section 2 Software Specifications when Using the Emulator SuperH™ Family E10A-USB Emulator
Page 46 of 46 REJ10J1941-0300 Rev. 3.00
Aug 25, 2010
The contents of the dialog box for setting [Memory Mapping] are shown below.
[From:] Enter the start address for the ranges.
[Setting:]
[ERAM to
FLASH]
Reflect the contents of the emulation RAM in the internal flash
memory when address allocation is cancelled.
[ERAM not
to FLASH]
Reflect no contents of the emulation RAM in the internal flash
memory when address allocation is cancelled.
[Reset All] Reset all emulation RAMs as default.
[OK] Reflect changes and close the dialog box for setting [Memory
Mapping].
[Cancel] Reflect no changes and close the dialog box for setting [Memory
Mapping].
Notes: 1. Operation is not guaranteed in cases where registers of the ERAM module are
manipulated from the [IO] window or in some other way.
2. For command-line syntax, refer to the online help file.
3. If an area of emulation RAM is not being used by the emulator, the user must not
allocate that emulation RAM to a ROM area; instead use the emulation RAM in its
original address area.
4. When using the emulation RAM, make the setting to disable flash memory
synchronization on halting the user program.
5. The function for setting of the emulation RAM is not available when the target device
is the SH72546R, SH72544R, SH72543R, or SH72531.