User`s manual

SuperH™ Family E10A-USB Emulator Section 2 Software Specifications when Using the Emulator
REJ10J1941-0300 Rev. 3.00 Page 45 of 46
Aug 25, 2010
The contents of the [Memory Mapping] dialog box are shown below.
[Mode]
[User] The emulator does not use the emulation RAM.
[Emulator] The emulator uses the emulation RAM.
[ERAM Setting]
[Edit…] Open the dialog box for setting [Memory Mapping] to change the
address ranges and attributes of the emulation RAM.
[Reset] Reset the selected emulation RAM as default.
[Reset All] Reset all emulation RAMs as default.
[OK] Reflect changes and close the [Memory Mapping] dialog box.
[Cancel] Reflect no changes and close the [Memory Mapping] dialog box.
Figure 2.8 Dialog Box for Setting [Memory Mapping]