User`s manual

Section 2 Software Specifications when Using the Emulator SuperH™ Family E10A-USB Emulator
Page 36 of 46 REJ10J1941-0300 Rev. 3.00
Aug 25, 2010
[Setting Method]
(i) Select the [Channel A] and [Channel B] check boxes in the [AUD function] group box of the
[Trace mode] page. Each channel will become valid.
(ii) Open the [Window trace] page and specify the bus cycle, memory range, and bus type that are
to be set for each channel.
Figure 2.5 [Window trace] Page
Note: When [M-Bus] or [I-Bus] is selected, the following bus cycles will be traced.
• M-Bus: A bus cycle generated by the CPU is acquired.
• I-Bus: A bus cycle generated by the CPU or DMA is acquired.