User`s manual

SuperH™ Family E10A-USB Emulator Section 2 Software Specifications when Using the Emulator
REJ10J1941-0300 Rev. 3.00 Page 19 of 46
Aug 25, 2010
12. Illegal Instructions
Do not execute illegal instructions with STEP-type commands.
13. Reset Input
During execution of the user program, the emulator may not operate correctly if a contention
occurs between the following operations for the emulator and the reset input to the target
device:
⎯ Setting an Event Condition
⎯ Setting an internal trace
⎯ Displaying the content acquired by an internal trace
⎯ Reading or writing of a memory
Note that those operations should not contend with the reset input to the target device.
14. MCU Operating Mode
Boot mode is not supported in the SH72546RFCC, SH72546R, SH72544R, SH72543R,
SH72531RFCC, SH72531FCC, and SH72531.
15. Writing Flash Memory Mode
Writing flash memory mode is not supported for the SH72546RFCC, SH72546R, SH72544R,
SH72543R, SH72531RFCC, SH72531FCC, and SH72531.
16. Starting up the Emulator
Selecting the [New ID Code] checkbox in the ID code dialog box and then clicking on the OK
button erases the whole EEPROM area as well as the ROM area.
17. Product Information Mat
When the SH72546RFC, SH72531RFCC, or SH72531FCC is used to emulate the SH72546R,
SH72544R, SH72543R, or SH72531, the contents of the information mat differ from those on
the actual chip.