User`s manual

Section 1 Connecting the Emulator with the User System SuperH™ Family E10A-USB Emulator
Page 12 of 46 REJ10J1941-0300 Rev. 3.00
Aug 25, 2010
When the circuit is connected as shown in figure 1.6, the switches of the emulator are set as SW2
= 1 and SW3 = 1. For details, refer to section 3.8, Setting the DIP Switches, in the SuperH
TM
Family E10A-USB Emulator User’s Manual.
1
TCK
TMS
RES
TDI
TDO
TRST
N.C.
GND
GND
GND
GND
GND
2
3
4
5
6
7
ASEMD
8
9
11
10
12
13
14
TCK
RES
TMS
TDO
TDI
TRST
Vcc
Vcc
N.C.
Target MCU
Vcc
Vcc
UVCC
Vcc
1 kΩ
Reset signal
All pulled-up at 4.7 kΩ or more
User system
Vcc = 3.3-V power supply
H-UDI port connector
(14-pin type)
Figure 1.6 Recommended Circuit for Connection between the H-UDI Port Connector and
MCU when the Emulator is in Use (14-Pin Type)