User`s manual

Section 1 Connecting the Emulator with the User System

1.1 Components of the Emulator

The E10A-USB emulator supports the SH7047F.

The supported operating modes are as follows:

 MCU expansion mode 2

 Single-chip mode

Note: When the SH7047F is used, set the FWP pin to 0 (low). To select MCU expansion mode

2, select the clock mode in FWP = 0 and MD3,2, and set MD1 = 1 and MD0 = 0. To

select the single-chip mode, select the clock mode in FWP = 0 and MD3,2, and set MD1 =

1 and MD0 = 1.

Table 1.1 lists the components of the emulator.