User`s manual

SuperH™ Family E10A-USB Emulator Section 1 Connecting the Emulator with the User System
R20UT2163EJ0200 Rev. 2.00 Page 5 of 43
May 23, 2013
Pin 1 mark
Notes:
1. Input to or output from the user system.
2. The symbol (#) means that the signal is active-low.
3. The emulator monitors the GND signal of the user
system and detects whether or not the user system
is connected.
25.0
23.0
6 x 2.54 = 15.24
(2.54)
0.45
Pin 1
Pin 8
Pin 7
Pin 14
Pin 1 mark
H-UDI port connector
(top view)
H-UDI port connector
(top view)
Pin No. Signal
1
2
3
4
5
6
7
8
9
11
10, 12,
and 13
14
TCK
TRST#
TDO
ASEBRK#
/ BRKACK
TMS
TDI
RESET#
N.C.
(GND)
UVCC
GND
Input/
Output*
1
*2
*2
GND
*3
Output
Input
Input
Output
Input/
output
Input
Input
Output
Output
SH7752
Pin No.
4.
When the user system interface cable is connected to
this pin and the MPMD pin is set to 0, do not connect to
GND but to the MPMD pin directly.
Note
User reset
*2
*4
Unit: mm
C18
B17
C17
K5
B18
D18
F1
Figure 1.3 Pin Assignments of the H-UDI Port Connector (14 Pins)