User`s manual
SuperH™ Family E10A-USB Emulator Section 1 Connecting the Emulator with the User System
R20UT2163EJ0200 Rev. 2.00 Page 6 of 43
May 23, 2013
N.C.
N.C.
MPMD (GND)
TCK
N.C.
AUDSYNC
N.C.
N.C.
AUDATA0
AUDATA1
UVCC_AUD
N.C.
N.C.
TMS
UCON# (GND)
N.C.
AUDCK
UVCC
N.C.
N.C.
RESET#
TDI
H-UDI port connector (top view)
Unit: mm
TDO
B18
D18
C18
C17
H3
Output
Output
Input/
Output
Output
Output
Output
Output
Output
Output
Output
Output
Input
Input
Input
Input
K5
F1
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
N.C.
B17
G1
J3
J4
H1
H2
N.C.
TRST#
ASEBRK#/
BRKACK
N.C.
AUDATA3
N.C.
AUDATA2
N.C.
N.C.
N.C.
N.C.
N.C.
N.C.
N.C.
19
38
137
38 2
6.91
25.4
Pin
No.
Signal
Input/
Output
Note
Pin
No.
Signal
Input/
Output
Note
*1
*1
SH7752
Pin No.
SH7752
Pin No.
*4
*3
*2
*2
*2
Notes:
1. Input to or output from the user system.
2. The symbol (#) means that the signal is active-low.
3. The emulator monitors the GND signal of the user system and detects whether or not the user system is connected.
4.
When the user system interface cable is connected to this pin and the MPMD pin is set to 0, do not connect to
GND but to the MPMD pin directly.
5. The GND bus lead at the center of the H-UDI port connector must be grounded.
User reset
Figure 1.4 Pin Assignments of the H-UDI Port Connector (38 Pins)