User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 5 Debugging
R20UT0363EJ0500 Rev. 5.00 Page 82 of 296
Aug 10, 2012
[Mode] Indicates the device name.
[Emulation mode] Selects the mode of emulation for user programs.
Normal: Normal execution of emulation for the user program.
No break: The user program is executed with settings of PC
breakpoints and hardware breakpoints temporarily disabled.
[UBC mode] Set the UBC mode.
Eml: The UBC is used as an event condition by the emulator.
User: The UBC is released to the user.
[PPC mode] Set the PPC mode.
Eml: The PPC is used in the Performance Analysis functions
of the emulator.
User: The PPC is released to the user
*
.
[AUD clock] This is the clock signal for the acquisition of AUD trace
information.
Lower frequencies correspond to a greater incidence of data
loss when real-time tracing is in use.
Set this item so that the frequency does not exceed the upper
limit on AUD clock frequency of the supported device.
For details on the upper limits of AUD clock frequency in
individual devices, refer to section 2.2.4, Notes on Using the
JTAG (H-UDI) Clock (TCK) and AUD Clock (AUDCK) in the
additional document, Supplementary Information on Using the
SHxxxx.
[JTAG clock] This is the transfer clock for signals other than AUD trace
signals.
Lower frequencies correspond to downloading taking longer
times.
Set this item so that the frequency does not exceed the upper
limit on TCK clock frequency of the supported device.
For details on the upper limits of TCK clock frequency in
individual devices, refer to section 2.2.4, Notes on Using the
JTAG (H-UDI) Clock (TCK) and AUD Clock (AUDCK) in the
additional document, Supplementary Information on Using the
SHxxxx.