User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 5 Debugging
R20UT0363EJ0500 Rev. 5.00 Page 80 of 296
Aug 10, 2012
Items that can be displayed in the sheet are listed below.
[Mode] Displays the CPU number.
[Step option] Sets the step interrupt option.
Disable interrupts during single step execution: Disables
interrupts
*
during step execution.
Enable interrupts during single step execution: Enables
interrupts during step execution.
[Reset assert (Auto Connect)] When the emulator is connected to the host computer and the
[CPU reset] function or [Reset after execution] function is used,
the reset signal is generated by the emulator.
Note: Includes the interrupts during a break.
CAUTION
Do not to use the [Reset assert (Auto Connect)] option unless the
port connector is properly connected as shown in Section 1.5,
Recommended Circuit between the H-UDI Port Connector and the
MPU of the additional document, Supplementary Information on
Using the SHxxxx. Using the [Auto connect] option without the
proper connection will damage the user system.
Note: The items that can be set in this dialog box vary according to the emulator in use. For
details, refer to the online help.